Piping on the left is a Rhinocoat® High Temp Conduit coated with a dual layer (15/5) fusion bonded epoxy and a carrier pipe with 300˚F polyisocyanurate foam. Piping on the right is an Insul-800 Elite System with RhinoJoint, Pyrogel® XT-e carrier pipe insulation and a conduit insulation of 400˚F high temp polyisocyanurate foam.
Insul-800 and Rhinocoat® High Temp Conduit Systems for steam distribution, condensate, high temp water, process fluids and fuel oil. These systems arrive on-site as a complete, trouble-free, long lasting, watertight heat distribution system.
- U.S. Government approved Conduit Systems are Class “A” (DDT) type drainable, dryable & air-testable.
- Pre-manufactured at Rovanco assures uniformed quality & eliminates any field fabrication
- All systems are engineered & factory fabricated to your specifications.
- Both systems are available with Pyrogel® XT-e insulation encasing the carrier pipe – which is featured on Rovanco’s “Elite” Conduit piping lines.
- Insulations used for carrier pipes and/or outer conduit can be urethane foam, 300˚ & 400˚F polyisocyanurate foam, mineral wool and Pyrogel® XT-e.
- These Conduit piping systems have carrier pipe sizes (1/2” through 36”) and are available in a wide range of materials including; Schedule 40 & 80 carbon steel, stainless steel, copper and others upon request.
- Outer jacket or conduit casing can be a variety of materials including; 175 mils minimum HDPE, carbon steel, stainless steel and spiral seam stainless, galvanized or aluminum. Other materials may be available upon request.
- Rovanco’s Rhinocoat® consists of a carbon steel outer jacket protected with a dual coat 15/5 fusion bonded epoxy. This 20 mils of total coating is 40% thicker than the world-wide standard. Hot dipped galvanized or red mil coating over carbon steel can be used for above ground applications.